Formulação líquida desenvolvida para uso como limpador alcalino para membranas de UF /MF. Compatível com todos os materiais de membranas.


  • Concentrated liquid formulation designed for use as a high pH cleaner of ultrafiltration and microfiltration membrane surfaces
  • Works to remove the most stubborn biofilms and organic foulants
  • Especially effective in removal of metal oxide deposits when used in a pH range of 9 – 10.5
  • Buffered so as not to exceed a pH of 12
  • Does not cause chemical hydrolysis of polypropylene and PVDF membranes
  • Compatible with most MF/UF modules
  • Certified by NSF to NSF/ANSI Standard 60 for use in potable systems

Typical Properties

  • Appearance: Clear yellow to amber liquid
  • Odor: Slight characteristic odor
  • pH (as is): >12
  • Solubility in water: Complete
  • Specific Gravity: 1.20 ± 0.05


  • 5 gallon pails, 55 gallon non-returnable plastic drums, 275 gallon totes

Safety and Handling

Store in a cool, dry and well ventilated area. Keep containers closed. Wash contaminated clothes before re-use. Wash thoroughly after handling.
For more information, see the Safety Data Sheet.

Chemical Feeding and Control

Prepare cleaning solution using potable water free of residual chlorine or other oxidizing agents. (RO permeate or DI water is preferred). Do not use hard water. Add 1-2 gallons of AWC UF-437 to every 100 gallons of water (1-2 % solution), depending on severity of fouling. Water must be heated to the maximum temperature allowed by the module manufacturer. Adjust pH to the highest pH allowable by the membrane manufacturer. If pH needs to be adjusted downwards, use HCl (31% Muriatic acid) and add only 0.1% by volume at a time. Mix thoroughly by recirculation before checking pH; repeat addition as necessary. If pH needs to be adjusted upwards, use NaOH (50% Caustic Soda) and add only 0.1% by volume at a time. Mix thoroughly by recirculation before checking pH; repeat addition as necessary.

Circulate cleaning solution throughout the modules, with the filtrate valve closed, in the feed direction for 30 min (for tubular designs). Reverse the direction of flow; recirculate for 30 more minutes. Repeat as necessary until desired cleaning results are achieved. AWC UF-437 should be added as necessary to the cleaning solution to maintain the pH range. Optimal iron removal occurs at pH of 9.0–10.5. For systems that allow back flushing, back flush with cleaning solution from the filtrate to the feed for 15 minutes. After the cleaning is finalized the modules must be flushed with MF/UF filtrate.